Autopilot Trainer · Practice guide

IAS vs VS: practise climbs and descents

By Laurens Drapers, creator of Autopilot Trainer
Checked against app version 1.4.2 · · 5 min read

In Autopilot Trainer, IAS adjusts pitch to hold a selected indicated airspeed. VS adjusts pitch to hold a selected vertical speed. Neither mode manages power for you: you still need to watch airspeed, vertical speed and the selected altitude.

What changes when you select each mode?

IAS and VS behaviour in Autopilot Trainer
In the appIASVS
Pitch aims to holdIndicated airspeedVertical speed
Initial reference on selectionCurrent indicated airspeedCurrent vertical speed, rounded to 100 ft/min
Vertical wheel changesSelected airspeedSelected climb or descent rate
Keep monitoringClimb/descent rate and powerAirspeed and power

The button in this app is labelled IAS. Adding power in an IAS climb allows a greater climb rate while pitch works to hold the target speed. In VS, selecting a rate does not guarantee that airspeed stays constant.

Exercise 1: climb in IAS

For a free introduction, open Academy and choose Climb in IAS. For the guided scene below, the full-app unlock is required: open More Tutorials → How to climb or descend? and choose Climb in IAS.

  1. Preview the scene and tap Start Lesson. Use the target altitude shown by the lesson; it is based on the selected practice location.
  2. Follow the prompts to select IAS and use the vertical wheel to set 110 KIAS. In this app, nose-up lowers the IAS reference and nose-down raises it.
  3. Add power as prompted. Use Start practice when the guide asks you to begin the flight segment. Observe how pitch holds the speed while the aircraft climbs.
  4. Watch the approach to the selected altitude: ALTS becomes active during capture, then ALT holds the altitude. Continue to monitor airspeed and adjust power as needed.

The 110 KIAS value belongs to this app’s guided scene. It is not a recommended climb speed for your aircraft.

Exercise 2: descend in VS

With the full-app unlock, open the same How to climb or descend? lesson and choose Descend in VS.

  1. Start the lesson and set the lower selected altitude shown by the guide. Press VS and check the active-mode display.
  2. Use the vertical wheel to select −500 ft/min. Follow the power prompt and then Start practice when instructed. The minus sign indicates a descent.
  3. Watch vertical speed and airspeed together. VS controls the rate through pitch; power still matters for the speed you see.
  4. Observe selected-altitude capture and the transition to ALT. Compare the result with the IAS exercise: the held reference was different, but both ended with altitude hold.

Check your understanding

If you want the app to hold a speed through pitch, which mode would you select? If you select VS, what else must you monitor? And why does pressing ALT early stop the climb near your current altitude instead of taking you to the selected altitude?

Review the armed-to-active capture sequence when you can perform the button sequence but still find the mode changes hard to follow.

Put it into practice

Try Quick Tour, Engage Autopilot and Climb in IAS for free on iPhone or iPad.

Try the free lessons

Available now on iOS.

Requires iOS 17.0 or later. Three introductory lessons are free. One-time lifetime unlock for all lessons and the full simulator.

Opti Orbit Autopilot Trainer iconOpti Orbit AutopilotTrainer

Newsletter

App updates and training notes, sent occasionally.

Company

© 2026 Opti Orbit Autopilot Trainer. All rights reserved.

Opti Orbit is a trading name of Sigmoid B.V.

Designed for iOS.